PIC24HJ12GP201-E/SO Microchip 16bit MCU

PIC24HJ12GP201-E/SO Overview

The PIC24H 16-bit device family employs a powerful 16-bitarchitecture, ideal for applications that rely on high-speed, repetitivecomputations, as well as control. The devices are pin compatible with thedsPIC33F family of devices, and share a very high degree of compatibility withthe dsPIC30F family devices. This allows seamless migration options from/toPIC24F, dsPIC30F and dsPIC33F devices.

Features

Operating Range

Up to 40 MIPS operation
Industrial temperature range (-40°C to +85°C)
Extended temperature range (-40°C to +125°C)

High Efficiency PIC24H core

Modified Harvard architecture
C compiler optimized instruction set
16-bit-wide data path, 24-bit-wide instructions
Linear program memory addressing up to 4M instruction words
Linear data memory addressing up to 64 Kbytes
71 base instructions, mostly one word/one cycle
Sixteen 16-bit general purpose registers
Flexible and powerful addressing modes
16 x 16 multiply operations
32/16 and 16/16 divide operations
Up to ±16-bit shifts for up to 40-bit data

Interrupt Controller

5-cycle latency
Up to 21 available interrupt sources
Up to three external interrupts
Seven programmable priority levels
Four processor exceptions

Digital I/O

Peripheral Pin Select Functionality
Up to 21 programmable digital I/O pins
Wake-up/Interrupt-on-Change for up to 21 pins
Output pins can drive from 3.0V to 3.6V
Up to 5V output with open drain configurations on 5V tolerant pins
4 mA sink on all I/O pins

System Management

Flexible clock options: - External, crystal, resonator, internal RC, fully integrated Phase-Locked Loop (PLL) and extremely low-jitter PLL
Power-up Timer
Oscillator Start-up Timer/Stabilizer
Watchdog Timer with its own RC oscillator
Fail-Safe Clock Monitor (FSCM)
Reset by multiple sources

Power Management

On-chip 2.5V voltage regulator
Switch between clock sources in real time
Idle, Sleep, and Doze modes with fast wake-up

Timers/Capture/Compare

Timer/Counters, up to three 16-bit timers: - Can pair up to make one 32-bit timer, one timer runs as Real-Time Clock with external 32.768 kHz oscillator and programmable prescaler
Input Capture (up to four channels): - Capture on up, down, or both edges, 16-bit capture input functions and 4-deep FIFO on each capture
Output Compare (up to two channels): - Single or Dual 16-bit Compare mode, 16-bit Glitchless PWM Mode

Communication Modules

4-wire SPI with framing supports I/O interface to simple codecs, supports 8-bit and 16-bit data and all serial clock formats and sampling modes
I2C™ with Full Multi-Master Slave mode support, 7-bit and 10-bit addressing, bus collision detection and arbitration, integrated signal conditioning, slave address masking
UART with LIN bus support, IrDA® encoding and decoding in hardware, High-Speed Baud Mode, Hardware Flow Control with CTS and RTS