LPC3220FET296/01,5 NXP 32bit MCU

LPC3220FET296/01,5 Overview

The LPC3220 operates at CPU frequencies of up to 266 MHz. The NXP® implementation uses an ARM926EJ-S CPU core with a Harvard architectur, 5-stage pipeline, and an integral Memory Management Unit (MMU).The LPC3220 also includes 128 kB of on-chip static RAM, a NAND flash interface, and an external bus interface that supports SDR and DDR SDRAM, as well as static devices. In addition, the LPC3220 includes a USB 2.0 full-speed interface, seven UARTs, two I2C-bus interfaces, two SPI/SSP ports, two I2S-bus interfaces, two single output PWMs, a motor control PWM, six general purpose timers with capture inputs and compare outputs, a Secure Digital (SD) interface, and a 10-bit Analog-to-Digital Converter (ADC) with a touch screen sense option.

Features

ARM926EJS processor, running at CPU clock speeds up to 266 MHz
Vector Floating Point (VFP) coprocessor
32 kB instruction cache and a 32 kB data cache
Up to 128 kB of Internal SRAM (IRAM)
Selectable boot-up from various external devices
Multi-layer AHB system that provides a separate bus for each AHB master
External memory controller for DDR and SDR SDRAM as well as for static devices
Two NAND flash controllers
Master Interrupt Controller (MIC) and two Slave Interrupt Controllers (SIC)
Eight channel General Purpose DMA (GPDMA) controller on the AHB
USB interface supporting either device, host (OHCI compliant), or On-The-Go
Four standard UARTs with fractional baud rate generation
Three additional high-speed UARTs intended for on-board communications
Two SPI controllers
Two SSP controllers
Two I2C-bus interfaces with standard open-drain pins
Two I2S-bus interfaces, each with separate input and output channels
Secure Digital (SD) memory card interface
General Purpose (GP) input, output, and I/O pins
10 bit, 400 kHz Analog-to-Digital Converter (ADC)
Real-Time Clock (RTC) with separate power pin and dedicated 32 kHz oscillator
32-bit general purpose high-speed timer with a 16-bit pre-scaler
Six enhanced timer/counters
32-bit millisecond timer driven from the RTC clock
WatchDog timer clocked by the peripheral clock
Two single-output PWM blocks
Motor control PWM
Keyboard scanner function allows automatic scanning of an up to 8 x 8 key matrix
Up to 18 external interrupts
Standard Arm® test/debug interface for compatibility with existing tools
Emulation Trace Buffer (ETB) with 2048 x 24 bit RAM allows trace via JTAG
Stop mode saves power
On-chip crystal oscillator
An on-chip PLL allows CPU operation up to the maximum CPU rate
Boundary scan for simplified board testing