STM8L001J3M3 STMicroelectronics 8bit MCU

STM8L001J3M3 Overview

The STM8L001J3 low-power microcontroller features the enhanced STM8 CPU core providing increased processing power (up to 16 MIPS at 16 MHz) while maintaining the advantages of a CISC architecture with improved code density, a 24-bit linear addressing space and an optimized architecture for low power operations.

The family includes an integrated debug module with a hardware interface (SWIM) which allows non-intrusive in-application debugging and ultra fast Flash programming.
All STM8L001J3 microcontrollers feature low power low-voltage single-supply program Flash memory. The 8-Kbyte devices embed data EEPROM.
The STM8L001J3 low power microcontroller is based on a generic set of state-of-the-art peripherals. The modular design of the peripheral set allows the same peripherals to be found in different ST microcontroller families including 32-bit families. This makes any transition to a different family very easy, and simplified even more by the use of a common set of development tools.
All STM8L low power products are based on the same architecture with the same memory mapping and a coherent pinout.

ECAD Model

Symbol

Footprint

Features

Supply voltage range 1.8 V to 3.6 V
Low power consumption (Halt: 0.3 μA, Active-halt: 0.8 μA, Dynamic Run: 150 μA/MHz)
STM8 Core with up to 16 CISC MIPS throughput
Temp. range: -40 to 125 °C

Memories

8 Kbytes of Flash program including up to 2 Kbytes of data EEPROM
Error correction code (ECC)
Flexible write and read protection modes
In-application and in-circuit programming
Data EEPROM capability
1.5 Kbytes of static RAM

Clock management

Internal 16 MHz RC with fast wakeup time (typ. 4 μs)
Internal low consumption 38 kHz RC driving both the IWDG and the AWU

Reset and supply management

Ultra-low power POR/PDR
Three low-power modes: Wait, Active-halt, Halt

Interrupt management

Nested interrupt controller with software priority control
Up to 6 external interrupt sources

I/Os

Up to 6 I/Os, all mappable on external interrupt vectors
I/Os with programmable input pull-ups, high sink/source capability and one LED driver infrared output

Peripherals

Two 16-bit general purpose timers (TIM2 and TIM3) with up and down counter and 1 channel (used as IC, OC, PWM)
One 8-bit timer (TIM4) with 7-bit prescaler
Infrared remote control (IR)
Independent watchdog
Auto-wakeup unit
Beeper timer with 1, 2 or 4 kHz frequencies
SPI synchronous serial interface
Fast I2C Multimaster/slave 400 kHz
UART with fractional baud rate generator
2 comparators with 1 input each