S6E2C48J0AGB1000A Cypress 32bit MCU

S6E2C48J0AGB1000A Overview

FM4 microcontrollers operate at frequencies up to 200 MHz and support a diverse set of on-chip peripherals for motor control, factory automation and home appliance applications. The portfolio delivers low-latency, reliable, machine-to-machine (M2M) communication required for Industry 4.0 - the fourth industrial revolution, using network-computing technologies to advance design and manufacturing.

Outstanding Performance

The FM4 portfolio operates at clock frequencies of up to 200MHz, and supports an operating voltage range of 2.7V to 5.5V. The devices incorporate 256KB to 2MB flash and up to 256KB RAM. The fast flash memory combined with a flash accelerator circuit (pre-fetch buffer plus instruction cache) provides zero-wait-state operation up to 200MHz. A standard DMA and an additional descriptor based DMA (DSTC), each with an independent bus for data transfer, can be used to further offload the CPU.

Functional Safety

The internal, trimmed RC oscillators function as an independent clock source for the clock supervisor and watchdog modules. The devices also feature a two-stage programmable Low Voltage Detector (LVD), a CRC hardware module, a Memory Protection Unit (MPU), and programmable emergency stop input for inverter motor control.

High-Performance Flash Memory

The high-speed, embedded flash memory features a true zero-wait-state operation at 72MHz. A flash accelerator with pre-fetch buffer and 16KB instruction cache allows zero-wait-state operation at up to 200MHz. The flash memory has an endurance of 100,000 write/erase cycles with up to 20 years of data retention. Once enabled, the flash security feature blocks any external read access to the flash memory and therefore secures firmware from being accessed. Many devices feature dual-operation flash for safe EEPROM emulation.

Low Power Consumption

The devices operate from 365uA/MHz, 1.5μA in deep RTC mode. The dedicated, low-power chip design includes clock and power gating. Clock gating can be used to reduce active power consumption by not clocking unused peripherals and therefore preventing them from consuming energy while not in use. Power gating is used to achieve very low current consumption in standby modes by internally disconnecting parts of the MCU from the supply voltage. There are multiple low-power options for finely tuned power-saving modes, and a dedicated power domain for deep standby modes.

Advanced Peripherals

The devices include support for Ethernet, CAN (controller area network), CAN-FD (CAN with flexible datarate) and USB2.0 (device and host). Motor-control features include up to three multifunction timers and a respective number of quadrature decoder units. The MCUs include up to three high-speed, 12-bit A/D converters, which can be triggered synchronously and have a conversion time of 0.5μs. Other features include HMI input devices, universal base timers, a sub-clock option, and flexible, multi-function serial interfaces supporting UART,SPI,I2C, and LIN.

Hardware 2D graphics accelerator

S6E2Dx Series devices feature a dedicated 2D graphics accelerator subsystem to drive TFT based HMI systems. With 512kbytes internal VRAM, and optional external SDRAM and HyperBus/Q-SPI interfaces to external flash, the hardware 2D accelerator with Blit engine enables impressive graphics HMIs with a very low BOM cost.